EverFocus EFC--02-1-A - Manual (Page 19)

11
1. Connect the pins on the lower right corner of the new module to the connector
on the bottom left corner of the installed module. Make sure that the pins fit
snugly into the receiving module.
2. Secure the module to the controller base board using the three screws (provided
in the module package).
Reader/Door Index Conversion
One EverAccess Flex Series controller can accommodate up to 4 door modules,
each of which controls 2 readers. The index conversion of readers and is displayed
below. The readers/doors are counted 1 to 8 from right to left:
Figure 2.2 Reader/Door Index Conversions
Please Note: Each card reader can be associated with any door index.
Please refer to section 5 for more details.
Terminal / LED Definitions
Main Module Terminal Definition
21 terminals are located on the main module, as shown in Figure 2.3: