EverFocus EFC--02-1-A - Manual (Page 45)

37
Set System PIN
A System PIN must be entered before the user can make management changes via
the controller keypad. The factory default System PIN is 000000. It is recommended
that the password is changed after the initial log-in for maximum security. Be sure to
keep the new password; if lost the system can only be accessed after purging all stored
data using
on the keypad.
Under the System Setting Menu, press ENT to set system PIN.
The LCD will display the following menu.
Enter a new system PIN. Enter it a second time to confirm. Press ENT to set the new
system PIN. Pressing at any time will exit the menu without changing the
system PIN.
Set Arm PIN
Arm PIN must be entered before the controller can be armed or disarmed via
controller keypad. The factory default arm PIN is 000000.
Under System Setting menu, press ENT at the window below to set arm PIN.
The LCD will display the following menu.
Enter a new arm PIN. Enter it a second time to confirm. Press ENT to set the new
arm PIN.
Erase All Events
The controller will record all events that occur, beginning immediately upon
powering on. These events can be purged by following the instructions below. If the
Set Time
__:__:__
Set SYS PIN
Input:
______
Set ARM PIN
Input:
______
CLR
CLR