EverFocus EFC--02-1-A - Manual (Page 42)

34
Pressing SYS on the keypad will bring up a prompt to enter a password, as shown
below:
Enter the system password and press ENT . If an incorrect password is entered three
times successively, the system will alarm automatically and lock the keypad for a
period of one minute.
The factory default password is 000000. In order to secure the controller, change the
password after the first login and keep the password in a safe place.
Display the Firmware Version
From the home screen, press to show the version information of the currently
installed firmware. An example is shown below:
Display the Number of Installed Modules
From the home screen, press to show the number of installed door modules
and alarm modules. An example is shown in the following figure. In this example, 4
door modules and 1 alarm module are installed in the controller.
Main Setting Items
The first level menus are displayed after entering the system menu. Use and
to toggle between menu options. The first level menu items are shown below:
System Setting Menu
Card Setting Menu
Reader Setting Menu
0
1
EverAccess
VER1.03
04-Door Modules
01-Alarm Modules
Reader Setting
Card Setting
System Setting
2005-12-16
FRI 09:38
1
Password
______