EverFocus EFC--02-1-A - Manual (Page 44)

36
Set Date
Under the System Setting Menu, press ENT at the window below to set the date.
The LCD will display the following menu. Use the numerical keys to enter the
current date as a six-digit number: (YY：MM：DD). The year must be in the range
2000-2099. Press
ENT to confirm the new date.
The date and time can be set at the controller. However, if the controller is connected
to a PC with EverAccess Flex Series software installed, the software will automatically
modify the controller date and time to match the time on the PC. If the controller
date and time are found to be incorrect, check the date and time on the management
PC.
Auto Daylight Savings Time
Under the System Setting Menu, press
ENT to adjust the settings for Auto Daylight
Savings :
Press
ENT to toggle the setting between Enabled/Disabled, Press
to exit
When auto daylight savings is turned on, the controller will automatically adjust DST
one hour forward from 1:59:59am to 3:00:00am on the first Sunday in April, and
adjust it back one hour from 2:59:59am to 2:00:00am on the last Sunday in October.
Set Time
Under the System Setting Menu, press ENT at to set the time.
The LCD will display the following menu. Use the numerical keys to enter the
current time as a six-digit number (HH：MM：SS). The time must be in the range
00:00:00--23:59:59. After entering the time, press
ENT to confirm.
Auto Daylight
Saving: Disabled Auto Daylight
Saving: Enabled
Auto Daylight
Saving Time
CLR
Set Time
Set Date
__-__-20__
Set Date