EverFocus EFC--02-1-A - Manual (Page 69)

61
Software Setup
Please Note: This is a brief instruction on EverAccess Flex Series Software for
a more detailed instruction guide please refer to the EverAccess Flex Series
Software Manual.
The next step after hardware installation is to configure the whole access control
system. Flex series controller has the ability to allow users configure the basic setting
through the keypad on the controller. But for the detailed, complicated settings, we
recommend to use the management software. To configure the system in software,
several major steps that you need to follow are shown as below:
1. Install the software in the control computer
2. Setup the user accounts who will use the software
3. Configure the controller and all other hardware settings
4. Configure the holidays, access group and the door control schedule
5. Enroll the cards and set the cardholders’ properties
Install the Software in the Control Computer
Just like installing any other software in the computer, inserts the software installation
CD into the CDROM, and run the setup program. Choose a special installation
folder if needed, otherwise just follow the setup wizard and choose the default
selection.
To run the software, you need the administrator privilege and the basic computer
requirement is as follows:
1. Pentium 3 CPU
2. Windows 2K, XP
3. 100M bytes free space in hard drive
4. 128M memory
For the details of the software installation and the minimum computer requirement,
please refer to the software manual.
Chapter
6