EverFocus EFC--02-1-A - Manual (Page 49)

41
Access Right Setting
Access rights of a card can be set using the following submenu:
Press ENT and system will show the access right of current card on all doors. Y
means the card has the right to pass the door, and N means the card does not have
the right. Flex controller will display the corresponding number of doors according to
installed door modules. In the example below, 4 door modules (8 doors) have been
installed on the controller. Press corresponding numeric keys to change access right
of current card on the door. Press
ENT to confirm. Press to exit without
effecting any change.
Group Setting
Each card belongs to an access group. Different group has different access rights and
time zone setting. Flex control support a maximum of 64 groups, each of which
supports a maximum of 32 time zone settings and defines access rights for all doors
in the system. Group setting is so complicated a process that it can only be performed
using the EverAccess control software. User can directly set group number for each
card using controller interface, but controller does not provide group setting function.
At the following submenu, press ENT to enter Group setting:
The group number of the current card will be displayed, as shown below:
Press numeric keys to enter the desired group number. Press ENT to confirm. Press
to exit without effecting any change.
Set Card PIN Setting
Each card in the EverAccess access control system is associated with a 4-digit PIN.
The PIN status can be set as enabled or disabled and if enabled, user is required to
enter the PIN every time he enters/exit the door if the reader is a keypad reader.
At the following submenu, press ENT to enter PIN setting:
Access Right
Setting
12345678
YYYYYYYY
Group Setting
Set Group:
01
CLR
CLR