Emerson Autochangeover Controllers AC8 - Manual (Page 107)

Setup Menu
99
A.6.4 Setup Zones
For details on this feature, see 7.6 - Setup System - Setup Zones.
A.6.5 Setup Output
For details on this feature, see 7.7 - Setup System - Setup Outputs.
Setup Zones
SETUP ZONES
Select zones and number
of devices in the zone
ZONES # DEVICES
1=ZONE 1 4
2=ZONE 2 0
3=ZONE 3 0
4=ZONE 4 0
5=RETURN TO SETUP MENU
6=RETURN TO MAIN MENU
SELECT A NUMBER:
># DEVICES IN ZONE 1
>[4]
>[
Setup Outputs
SETUP OUTPUTS
Setup output of device
Select output to edit
OUTPUT DEFINITION *******************************************
NO=NORMALLY OPENED
1=DEVICE_1 NO-OP-E-E NC=NORMALLY CLOSED
2=DEVICE_2 NO-OP-E-E
3=DEVICE_3 NO-OP-E-E OP=OPERATING/ON
4=DEVICE_4 NO-ST-E-E ST=STANDBY MODE
5=DEVICE_5 NO-NU-E-E NU=NOT USED
6=DEVICE_6 NO-NU-E-E
7=DEVICE_7 NO-NU-E-E D=DISABLE DEVICE ON ALARM CONDITION
8=DEVICE_8 NO-NU-E-E E=LEAVE DEVICE OPERATING ON ALARM CONDITION
9=RETURN TO SETUP MENU
0=RETURN TO MAIN MENU
D=DISABLE DEVICE IN EMERGENCY POWER OP
E=LEAVE DEVICE OPERATING (EMERGENCY POWER OP)
*******************************************
SELECT A NUMBER:1
>SET TO NORMALLY OPENED(NO) OR NORMALLY CLOSED(NC)
>[NO]
>[]
>DEVICE_1 TO OPERATING/ON(OP), STANDBY MODE(ST), NOT USED(NU)
>[OP]
>[]
>DEVICE_1 TO ENABLE(E) OR DISABLE(D) DEVICE ON ALARM
>[E]
>[]
>DEVICE_1 TO ENABLE(E) OR DISABLE(D) DEVICE IN EMERGENCY POWER OP
>[E]
>[