Honeywell NXL - Manual (Page 48)

48(96) Cabling and connections Honeywell Honeywell Honeywell Honeywell
6
Figure 6-23. Jumper selection for NXL HVAC, MF4 – MF6
! ! ! !
WARNING
Check the correct positions of the jumpers. Running the motor
with signal settings different from the jumper positions will not
harm the frequency converter but may damage the motor.
! ! ! !
NOTE
If you change the AI signal content also remember to change
the corresponding parameters (S6.9.1, 6.9.2) in System Menu.
nxlk54.fh8
= Factory default
Jumper block X 9 :
Voltage input; 0...10V
0...20mA; Current input
Jumper block X 8 :
AI1 mode
Termination resistor RS 485 is in use
Termination resistor RS 485 is not used
Jumper block X 1 3 :
AI2 m ode
0...20mA; Current input
Voltage input; 0...10V Voltage input; 0...10V
(differential)