HP 2500C Series - Manual (Page 107)

Install / Uninstall 4-1
Chapter 4 Install / Uninstall
Installing Printer Software from CD
To install the printer software, you will need at least 8 MB of RAM if Microsoft
Windows 3.1x, Windows 95 or 98 is installed as the operating system. For Windows NT
4.0 systems, you will need a minimum of 16 MB of RAM.
For Macintosh, to install the PostScript printer software, you need at least a 68040
computer with OS 7.53 installed. This printer software is only available for HP 2500CM
printer or the PostScript Upgrade Kit.
System requirements for the printer software may vary in different countries; please refer
to System Requirements (Chapter 1) for minimum and recommended system
requirements .
The HP 2500C Series printer software is available in the Starter CD.
Note for Windows 95 users
If you see the message, "New Hardware Found", before or during installation, select
Do not install a driver (Windows will not prompt you again), and click OK. Then
follow the instructions below to install the printer software.
If you see the Update Device Driver box, click Next, then Finish. Follow the
instructions below to install the printer software.