HP 2500C Series - Manual (Page 183)

Removal and Replacement of Parts (without Calibration) 7-33
Replacement of Parts
Replacement of Carriage Motor
You will be removing the carriage motor from the printer and installing a new carriage motor.
Removing the Carriage Motor
Step 1. Remove the Paper Knob (refer to the
procedures in Removing the Paper Knob
from Replacement of Paper Knob).
Step 2. Unlatch the catches under the fan and
remove casing. Set the cover aside.
Step 3. Disconnect the connector leading to the
carriage motor.
Step 4. Remove the screws on top of the carriage
motor. Holding on to the motor because of
the tension created by the drive belt.
Step 5. Unattach the drive belt from the carriage
motor.