Replacement of parts – HP 2500C Series User Manual
Page 169
Removal and Replacement of Parts (without Calibration) 7-19
Replacement of Parts
Installing the Power Knob
Step 1. Fit the latches on the printer to the holes on both sides of the new knob. Make sure the knob is
secured properly.
Step 2. Reinstall the ink supply station cover.
Step 3. Replace the screw in any of the two screw holes given near the LCD and LED connectors.
Step 4. Reinstall the key panel by latching the hinges behind first.
Step 5. Snap the panel into the latches from the right side first towards the left side. Make sure the
connectors are properly covered.
Step 6. Replace the two screws at the top of the panel.
Step 7. Reinstall the LCD cover by fitting in the hinges at the back first before pushing it down from the right
first, then the left. Make sure the cover snaps into place.
Step 8. Close the top cover of the printer.
Step 9. Reinstall the output tray (Tray 1) into place.
Step 10. Cover the service station with the side cover. Make sure it is fitted in properly.
Step 11. Replace the two screws for the service station side cover.
Step 12. Close the rear access door.
Step 13. Reinstall the printhead access door by fitting in the tabs on the left of it to the top cover and unfold
downwards. Flip the ink cartridge down.
Step 14. Plug in the power cord and turn on the printer.