HP 2500C Series - Manual (Page 178)

Removal and Replacement of Parts (without Calibration) 7-28
Replacement of Parts
Installing the Main Case
Step 1. Pull the paper knob out and place the new main case down.
Step 2. Replace the two screws at the top of the main case.
Step 3. Reconnect the LCD and LED connectors.
Caution!
Please note that the colors of the wiring of the LCD connector are different from that of the LED
connector. When connecting, please check that the sequences of the colors of the connectors match on
both ends.
Step 4. Replace the remaining components for the Power Knob (refer to Steps 3-14 of Installing the Power
Knob from Replacement of Power Knob.)