Replacement of parts – HP 2500C Series User Manual
Page 170
Advertising
Removal and Replacement of Parts (without Calibration)
7-20
Replacement of Parts
Replacement of Power Supply
You will be removing the power supply from the printer and installing a new power supply.
Removing the Power Supply
Step 1. Follow Steps 1-9 of Removing the Power
Knob from Replacement of Power Knob.
Step 2. Locate the side of the power supply and
unscrew five screws (one of which is
attached to the ESD strap). Set the screws
aside.
Step 3. Lift up the cover of the power supply. Be
careful of the ESD clip.
Step 4. Slide the power supply out. Be careful of
any cable or wire.
Step 5. Disconnect the power supply connector.
Advertising