Honeywell MK VI - Manual (Page 233)

Honeywell
MK VI MK VIII EGPWS Installation Design Guide
Proprietary notice on title page applies
CAGE CODE: 97896 SCALE: NONE SIZE: A DWG NO: 060-4314-150 REV: SHEET 233
If bits 15-18 right range output from the EGPWS does not match right MFD range (via label 171), then
display white “RANGE MISMATCH” on the right PFD and MFD.
Label 051 If bit 17 = 1 then display white “TERRAIN OFF” message on PFD and MFD.
Labels 052-055 EGPWS ASCII characters are not used. Green “TERRAIN” on PFD and MFD by EFIS.
Label 274
If bit 13 or 22 = 1 then display red “PULL UP” on left and right PFD.
If bit 12 or 23 = 1 then display amber “GND PROX” on left and right PFD.
If bit 14 = 1 then display white “GPWS FAIL” message on PFD.
If bit 15 = 1 then display red “WIND SHR” message on PFD.
If bit 17 = 1 then display white WNDSHR FAIL” message on PFD.
If bit 18 = 1 then display amber “WIND SHR” message on PFD.
If bit 24 = 1 then display amber “TERRAIN FAIL” message on PFD and MFD.
If bit 27 = 1 then display amber “TERRAIN NA” message on PFD and MFD.
If bit 28 = 1 and display configured for Pop Up on pilots side, then Pop Up Terrain on left MFD.
If bit 29 = 1 and display configured for Pop Up on copilots side, then Pop Up Terrain on right MFD.
If bit 14, bit 17, and bit 24 = 1 then display amber “EGPWS SYS FAIL” on PFD in lieu of “GPWS
FAIL” and “WNDSHR FAIL” messages on PFD.
If bits 30 and 31 = 01 (Functional Test) then display white “TERRAIN TEST” on PFD and MFD.
8. Terrain can be displayed on the PFD and MFD.