FUJITSU MHZ2250BJ - Manual (Page 280)

Operations
6.4.3.3 Full hit
In this situation, all read requested data is stored in the data buffer. Transfer of the
read requested data is started from the location where hit data is stored. For data
that is a target of caching and remains before a full hit, the data is retained when
execution of the command is completed. This is done so that a new read-ahead
operation is not performed. If the full hit command is received during the read-
ahead operation, a transfer of the read requested data starts while the read-ahead
operation is in progress.
1) An example is the state shown below where the previous read command is
executing sequential reading. First, HAP is set at the location where hit data
is stored.
HAP (It is reset to the hit data location for transfers.)
HAP end location of the previous read command
DAP end location of the previous read command
Cache data Full hit data Cache data
HAP
DAP
2) The read requested data is transferred, and a new read-ahead operation is not
performed.
(stop)
HAP
Cache data Full hit data Cache data
6-18 C141-E280