FUJITSU MHZ2250BJ - Manual (Page 299)

7.4 Disk Drive Removal Procedure
7.4 Disk Drive Removal Procedure
The method and procedures to demount the disk drive to check the jumper
terminal, change the jumper position, or replace the device differ depend on the
system cabinet structure. Therefore, for actual working procedures, the specific
conditions necessary for each system must be determined. The general removal
procedures, with notes, are as follows.
a) Disconnect the power-interface cable.
b) Remove the screws that attach the drive and remove the drive from the system
cabinet.
c) When storing or transporting the drive, pack it an antistatic bag in compliance
with section 7.1.2 (5) d. and (5) e..
To protect the device from damage and prevent the worker getting hurt, observe
the following cautions and precautions in Subsection 7.1.1.
Damage or Device damage
1. Perform any removal after the system power is completely
disconnected. The cable must not be disconnected and the
screws that attach the drive must not be removed with the
power ON.
2. Do not move the drive and attach or detach the connector until
it comes to a complete stop (about 30 s after the power is
turned OFF).
3. Perform the human body grounding to discharge any static
electricity from your body. (Be sure to wear a wrist strap)
7.5 Spare Disk Drive
See Subsection 1.2.2, "Model and product number," to order a disk drive for
replacement or as a spare.
C141-E280 7-15