Fostex PD606 - Manual (Page 114)

114
Location Recorder Model PD606
Chapter 6: Advanced operations
6) After making audio file selection, press the [ENTER/YES] key.
The PD606 starts file copy to the destination medium (DVD-RAM disk or partition).
During file copy, the display shows estimated time and space remaining progress
indication for file copy. When file copy completes, “Completed!” is shown on the
display and the PD606 stops disk access.
7) Pressing the [EXIT] key repeatedly to exit the MENU mode.
<Note>: If the available recording space of the copy destination is smaller than the
copy source size, “Over copy size!” is shown and the display returns to the previous
screen for selecting an audio file.
<Note>: If you set a recorded DVD-R/RW or CD-R/RW disk to the copy destination,
the display shows “Write protected!” or "No Blank disk". In such a case, do the fol-
lowing.
• When a recorded DVD-R or CD-R disk is set:
After briefly showing "Write protected!", the display shows the screen for selecting
the drive of the copy destination. Change the disk.
• When a recorded DVD-RW or CD-RW is set:
After briefly showing "No Blank disk", the display shows the popup screen as below.
If you erase the disk, press the [ENTER/YES] key. If you do not erase the disk, press
the [EXIT] key. If erasing the disk is properly completed, the display automatically
returns to the execution screed for disk copy.
<Note>: After file copy to a DVD-R/RW or CD-R/RW is completed, the disk is auto-
matically finalized. While finalizing the disk, the popup screen as shown below ap-
pears. When you copy an audio file whose size is less than 1GB to a DVD-R/RW disk,
the unit must write readout area from the center of the disk to the 70mm diameter
position, resulting longer finalizing time.
We recommend using a CD-R/RW disk when you make a file copy of an audio file
whose size is less than 650 MB.
If you select "<All Select>" at the bottom of the file list on the screen and press the
[FILE SEL] key, all audio files are selected and checkmarked.