Fostex PD606 - Manual (Page 216)

216
Location Recorder Model PD606
Chapter 9: Specifications
Inputs/outputs
* 0dBu = 0.775Vrms, 0dBV = 1Vrms, Reference level: -20dBFS
ANALOG INPUT (CH1 ~ 6) Connectors : XLR-3-31 type (balanced, pin 2: hot)
LINE Input impedance : More than 10k
Ω
Input level : +4dBu ~ -32dBu
Maximum input level : +24dBu
MIC Input impedance : More than 2k
Ω
Input level : -34dBu ~ -70dBu
Maximum input level : -14dBu
ANALOG OUTPUT (TRK1 ~ 6) Connectors : XLR-3-32 type (balanced, pin 2: hot)
Output load impedance : More than 10k
Ω
Reference output level : +4dBu
Maximum output level : +24dBu
STEREO BUS OUT Connector : XLR-5-32 5PIN type (balanced)
Output load impedance : More than 10k
Ω
Reference output level : +4dBu/-10dBu/-60dBu (The reference output
level is selected in the SYS SETUP menu of the
MENU mode.)
Maximum output level : +24dBu
PHONES Connector : 6mm dia stereo phone jack
Applicable load impedance : More than 32
Ω
Maximum output level : 200mW (at 32
Ω
)
DIGITAL IN/OUT Connector : D-sub 25pin
Format Input : IEC60958 Part2 (S/P DIF) or IEC 60958 Part3
(AES/EBU), auto selection
Output : IEC60958 Part2 (S/P DIF) or IEC 60958 Part3
(AES/EBU), The format of an output signal is
selected in the SYS SETUP menu of the MENU
mode.
TIME CODE IN Connector : XLR-3-31 type (balanced, pin 2: hot)
Format : SMPTE/EBU
Input impedance : More than 20k
Ω
Reference input level : 2V p-p
Minimum input level : 0.25V p-p
TIME CODE OUT Connector : XLR-3-32 type (balanced, pin 2: hot)
Format : SMPTE/EBU
Output impedance : Less than 1k
Ω
Reference output level : 2V p-p
Output load impedance : More than 600
Ω
VIDEO/WORD IN Connector : BNC type (auto software selection)
Reference input level : TTL level (with 75
Ω
termination switch)
WORD OUT Connector : BNC type
Output level : TTL level
PARALLEL REMOTE Connector : MINI DIN 8pin (female)
9P-REMOTE Connector : D-sub 9pin
USB (KYBD) Connector : USB Series A Receptacle
USB (PC) Connector : USB Series B Receptacle
USB (HOST) Connector : USB Series A Receptacle