FARGO electronic Pro-L - Manual (Page 18)

Getting Started
3
Section 3: Getting Started 13
A. CHOOSING A GOOD LOCATION
Place the unit in a location with adequate air circulation to prevent internal heat
build up.
1. Use the dimensions specified in Section 10 as a guideline for the minimum
clearances to the unit.
NOTE: Allow for adequate clearance above the unit to accommodate the height of the unit with its
cover open.
2. Do not install unit (a) near heat sources such as radiators or air ducts, or (b) in a
place subject to direct sun-light, excessive dust, mechanical vibration or shock.
B. ABOUT MOISTURE CONDENSATION
If the unit is brought directly from a cold to a warm location, or is placed in a very
damp room, moisture may condense inside the unit. Should this occur, print
quality may not be optimum. Leave the unit turned OFF in a warm, dry room for
several hours before using. This will allow the moisture to evaporate.
proL.qxd 8/6/2000 3:30 PM Page 13