FARGO electronic Pro-L - Manual (Page 35)

30 Section 5: Card Laminating
Pro-L Card Printer User’s Manual
5. Place the take-up end of the roll in between the two black Lamination Drive
Hubs located on the far left-hand side of the printer’s interior. Load the take-up
end of the roll just as you loaded the supply end in step 4. When loaded
properly, the overlaminate material should feed underneath both ends of the
overlaminate roll.
6. Close the cover. When you start to print, the Lamination Drive Hubs will
automatically engage the overlaminate core notches.
IMPORTANT! Do not reverse the overlaminate roll. Damage may occur to the lamination roller!
Supply Roll
Take-up Roll
proL.qxd 8/6/2000 3:30 PM Page 30