FARGO electronic Pro-L - Manual (Page 68)

3. If the PolyGuard chip is being placed more toward a card’s bottom edge (as
shown), move the Card Guide Rail slightly toward the front of the printer
(opposite the direction you would like the chip to move).
4. Always make very slight adjustments to the Card Guide Rail, and run a test
print after each adjustment until the optimum chip position is found. Also, be
sure the Card Guide Rail always remains parallel to the card path and that the
screws loosened in step one are retightened after each adjustment.
Section 8: Mechanical Adjustments 63
Pro-L Card Printer User’s Manual
proL.qxd 8/6/2000 3:30 PM Page 63