FARGO electronic Pro-L - Manual (Page 63)

58 Section 8: Mechanical Adjustments
Pro-L Card Printer User’s Manual
1. Open the Card Hopper Door located on the right-hand side of the printer’s
exterior by grasping the top of the door and pulling straight down. Allow the
door to swing completely open.
2. As you are looking straight into the Card Hopper, locate the left Card Input
Guide and loosen the two screws which fasten it to the back plate of the Card
Hopper.
3. Once these two screws have been loosened, it is possible to move the left Card
Input Guide slightly to the right or to the left. Insert the stack of cards.
4. Adjust the left Card Input Guide so it rests flush against the side of the card
stack, and re-tighten the two screws loosened in the previous steps. Adjustment
to the left Card Input Guide is now complete. If the cards being inserted are
2.3” (58mm) or wider, refer to Part B of this section.
B. ADJUSTING THE INTERNAL CARD GUIDES
Two Internal Card Guides reside inside the printer. These Internal Card Guides are
also adjustable to accommodate varying card widths. Although these card guides
are spring-loaded and will automatically adjust to slight card width variations, a
manual adjustment must be made in order for the printer to accept cards 2.3”
(58mm) or wider. Please refer to the following steps to adjust both of the Internal
Card Guides:
1. Open both Top Covers of the printer by pressing the Cover Release Buttons.
Allow the covers to swing up and open.
2. Remove the ribbon and overlaminate rolls from the printer.
Drive Rollers
Internal
Card Guides
Card Guide Screws
Card Guide
Mounting Screws
proL.qxd 8/6/2000 3:30 PM Page 58