FARGO electronic Pro-L - Manual (Page 66)

7. Rotate the screws clockwise to move the Card Separator Flap upward or
counter clockwise to move the flap downward. If inserting thicker cards, move
the Card Separator Flap downward. If inserting thinner cards, move the flap
upwards.
8. When adjusted properly, the space between the Card Separator Flap and the
first Card Feed Roller should be approximately the same as the thickness of a
single card. To determine this, load two cards into the Card Hopper, then look
inside the printer. Of the two cards, only the top card should appear above the
Card Separator Flap as shown in this side view illustration.
9. Once you have adjusted the Card Separator Flap to the optimum level, tighten
the screws loosened in step 5 to secure the Card Separator Flap in place.
10. Adjustment to the Card Separator Flap is now complete. Re-install the ribbon
and cards, and shut the printer’s Top Cover and Card Hopper Door.
Section 8: Mechanical Adjustments 61
Pro-L Card Printer User’s Manual
Top Card Card Feed Roller
Card Input Tray Card Separator Flap
proL.qxd 8/6/2000 3:30 PM Page 61