FARGO electronic Pro-L - Manual (Page 34)

Section 5: Card Laminating 29
Pro-L Card Printer User’s Manual
2. The supply end of the overlaminate roll is the side containing the fresh, unused
portion of the overlaminate. The take-up end is the other side.
3. Open the top-left cover of the printer by pressing its Cover Release Button.
Allow the cover to swing up and open.
4. With the cover open, place the supply end of the overlaminate roll in between
the two black Lamination Drive Hubs located just to the left of the printer’s
Card Flipping Mechanism. Make certain that the overlaminate material is fed
from underneath the roll. HINT: The Lamination Drive Hub nearest you, as
you are looking into the printer from the front, is spring loaded. Use the end
of the roll’s supply core to push in this hub when inserting the overlaminate
roll.
Supply
Take-up
Card Flipping
Mechanism
Take-up
Lamination
Drive Hubs
Supply
Lamination
Drive Hubs
proL.qxd 8/6/2000 3:30 PM Page 29