FARGO electronic Pro-L User Manual

Page 30

Advertising
background image

Section 4: Ribbons and Cards 25

Pro-L Card Printer User’s Manual

1. Remove a stack of 100 or fewer cards from the card packaging. Do not touch

the area of the card where you intend to print. Oil or dirt from your hands can

impair print quality.

2. Open the Card Hopper Door located on the right-hand side of the printer’s

exterior by grasping the top of the door and pulling down. Allow the door to

swing completely open.

3. Insert the stack of cards into the printer by depressing the spring loaded Card

Input Tray and placing the cards between the Card Input Guides (see Section 8

for further Card Input Guide information). Always load cards with the top or

primary print side facing up. If inserting cards with a magnetic stripe, be sure

that the magnetic stripe is positioned downward and that the stripe is oriented

toward the rear of the printer. If inserting smart cards or cards with a pre-

punched slot, be sure the smart card chip is positioned upward and that the

chip or slotted end of the card is inserted first.

Card Hopper Door

Card Input Tray

Card Input Guides

Card Input Tray

proL.qxd 8/6/2000 3:30 PM Page 25

Advertising