GE HC HP - Manual (Page 13)

GE MDS Intrepid-HC HP Installation Guide 1-7
Assembling the Pole Mount Kit
The Pole Mount Kit is used to connect the Hanger Kit (together with the RFU and OCB) to the pole.
The kit consists of a single metal plate with a clamp assembly.
Important: The diameter of the pole upon which the kit is mounted must be between 50 mm (2") and
125 mm (5").
To assemble the Pole Mount Kit on the pole:
1. Open the Pole Mount Kit clamp, and assemble the kit on the pole, as shown in the following illustration.
2. Fasten the kit to the pole using the 4 screws, as shown in the photo above.
Four Screws
Fastening the
Pole Mount Kit
to the Pole