GE HC HP - Manual (Page 49)

GE MDS Intrepid-HC HP Installation Guide 2-7
Setting the Local TX Frequency Channel
If the TX frequency was previously defined using the HyperTerminal, use this screen only to verify that the correct
frequency was set.
1. Select Configuration, RFU Left/Right, RFU Configuration, or click the RFU icon in the tool bar.
At the top of the window, the system displays TX/Rx ranges, the gap between them, and the channel
bandwidth.
RFU Configuration Window
Note: In the window shown above, the RFU illustration shows two antennas. Only one antenna appears in the
illustration if the IFC (IF Combiner) is not supported.
2. The RFU Parameters area is read-only. The Duplex Frequency value changes in accordance with the TX/RX
frequency values.
3. You can change the TX and RX frequencies of the ODU in one of the following ways:
Manually enter the TX frequency and/or RX frequency (6, 7, 8, 10, 11 GHz only) in the respective fields.