GE HC HP User Manual
Page 85
MDS Intrepid-HC HP Installation and Operation
3-11
Interoperability Verification
Connect the customer end equipment to the line interfaces and verify correct operation.
Further interoperability tests should be performed in accordance with the specific requirements of the
connected end equipment.
Management Verification
Install network management software on the PC and launch the program.
Verify that you can manage the link and that you are able to perform changes to the link configuration
(frequency channel, TX power, system name, time & date, etc.) via the NMS.
Verify that the NMS reports the correct parameters when performing the above.
Verify that there are no active alarms on the link.
If the management station is located a t a remote site (Network Operation Center), verify that the
management station can manage the link and receive traps.