Motorola GT10 - Manual (Page 118)

GT10/GT30 6.2 Entering Configuration Settings with GTWIN
95
6.2 Entering Configuration Settings with GTWIN
This section describes how configuration settings for the GT30 are entered from GTWIN
screen creation tool.
6.2.1 Opening the GT Configuration Settings
The GT configuration settings are set by selecting [Configuration] on the menu
displayed by clicking with the mouse on [File] or pressing the Alt + F keys. Then select
the “GT Configuration” sub–menu under [Configuration].
Configuration Settings
GTWIN Configuration ––– These are operating environment settings for GTWIN.
GT Configuration ––– These are configuration settings for the GT30. The file is sent
from GTWIN to the GT30 after the settings have been entered.
6.2.2 GT Configuration Settings: “Basic Setup”
Selecting [Configuration] on the [File] menu of GTWIN and then the sub–menu [GT
Configuration] displays the “Basic Setup” screen shown below.
This is used to specify the basic communication area used for communication between
the GT30 and PLC, and the environment required for GT30 operation.