Motorola GT10 - Manual (Page 124)

GT10/GT30 6.2 Entering Configuration Settings with GTWIN
101
[Delete] ––– This deletes screens registered for auto–paging.
[Save] ––– This saves the settings for the screen number, time, and jump destination
as auto–paging settings.
6.2.5 GT Configuration Settings: “Startup Screen Settings”
Clicking on “Start–up Screen” in the “GT Configuration” dialog box displays the screen
shown below. Here, the screen displayed when the GT30 is booted can be specified.
“Start–up Screen” screen
This is used to specify the screen that will be displayed when the GT30 is booted, as
well as the time it will be displayed. Clicking on the
button for each of the items
displays a “Value Set” dialog box where the values can be specified.
Start–up Screen No. ––– This specifies the number of the screen that will be displayed
when the GT30 is booted. Clicking on the
button displays a “Value Set” dialog box
where the value for the start–up screen number can be specified.
Display Time ––– This specifies the time for which the startup screen specified above
will be displayed. The value can be set to any number between 0 and 255 seconds.
Clicking on the
button displays a “Value Set” dialog box where the start–up delay
time can be specified.
KEY POINTS
When the above settings are entered, the screen specified with the
“Startup Screen No.” parameter is displayed for the amount of time
specified with the “Display Time” parameter.
When the amount of time specified with the “Display Time”
parameter elapses, the screen corresponding to the number stored