Motorola GT10 - Manual (Page 49)

GT10/GT30 3.1 Setup Procedure for the GT10
26
3.1 Setup Procedure for the GT10
The GT10 should be set up using the procedure outlined below.
(1) Setting the “Configuration File” with GTWIN
The GT10 has an internal file called the “Configuration file”, which is used to determine
various operating environment parameters. When the GT10 is shipped from the factory,
the settings listed below are set for the parameters in the configuration settings file. If
changes are made to these settings, they are made from GTWIN screen creation tool.
(For detailed information on changing settings, see page 73 and subsequent pages.)
If the GT10 is being used without changing the factory settings, the following setup
procedure is not necessary.
Contents of configuration settings for GT10 when shipped from the factory
Classification Item Setting contents
Basic Setup
Area for basic
communication
with PLC Mode : GT10 mode
Word area: DT0 to DT2
Bit area
: WR0 to WR2
Communication
parameter
COM. port
Communication speed: 19200 bits/s, data length: 8 bits, stop bit: 1 bit, parity: odd
<Communication error temporary processing> Retries: 3, error code displayed
(not held)
parameter
settings
TOOL port
Communication speed: 19200 bits/s, data length: 8 bits, stop bit: 1 bit, parity: odd
<Through function local setting> None
Auto paging Automatic paging No
Startup screen
Startup screen No. 00
Startup screen
settings
Rise delay time 0 seconds
Clock GT main unit clock / external transmission: No
Other settings
Backlight control Not turned off automatically
Other settings
Touch operation
sounds Valid
Hold PLC Device Holds a PLC device Not held
GT internal
device hold GT internal device
hold Not held
Always confirm “Basic communication area to PLC” under “Basic Setup”
This is an internal device area that comes already provided in the GT10 for the purpose
of communicating with a PLC. If the factory settings are to be changed, the setup
procedure must be carried out. For detailed information, please see page 29.
(2) Connect the GT10 and the personal computer.
After the settings have been entered with GTWIN, connect the computer and the GT10,
using the screen transfer cable.
GTWIN
GT10
Screen transfer
cable (AFC8513D)