Motorola GT10 User Manual
Page 31
GT10/GT30
1.3 GT30 Names and Functions of Parts
8
(3) Power supply terminal
The operation power supply is connected here.
(4) COM. port (PLC/external device connection port)
A device such as a PLC, a higher–order computer, or a microcomputer board can be
connected to this RS232C port. (One communication connector is provided as an
accessory when the unit is shipped.)
(5) TOOL port (GTWIN connection port)
This port is used to connect a personal computer in which the screen creation tool
GTWIN has been installed, using a dedicated cable (AFC8513).
(6) Operation mode setting switches
The operation mode setting switches control the ability to shift to the system menu, and
other functions.
Switch no. Function
OFF
ON
1
Usage inhibited
Should always be in the OFF position
when unit is used
2
Inhibits system menu shift
Shift possible Shift inhibited
3
Usage inhibited
Should always be in the OFF position
when unit is used
4
when unit is used
(7) Waterproof packing
This assures that the front panel is waterproof. One piece is provided as an accessory
when the unit is shipped.
CAUTION
With the GT30, screen data and configuration settings are stored in the
internal F–ROM. Clock data and PLC device hold data are stored in the
internal SRAM, however, and can be backed up by the lithium battery (a
replaceable battery). When replacing the lithium battery, be sure to
insert the new battery within 20 seconds of removing the old one, to
avoid losing the data.
ON
OFF
4
3
MODE
1 2
Operation mode setting
switches
(settings when shipped)