Motorola GT10 - Manual (Page 55)

GT10/GT30 3.2 Setting the Basic Communication Area, GT10 and PLC
32
sub–menu. Turn on the radio button for “IOP01 Mode” in the
displayed dialog box.
For information on the displayed dialog box, please see “Basic
Setup” under “GT10 Configuration Settings” on page 73.
Map of the basic communication area for conventional models
(conventional name: system area)
If the IOP01 mode is set, the basic communication area map for the
GT10 is as follows.
Reference data area
Bit configuration
Address
F E D C B A 9 8 7 6 5 4 3 2 1 0
n BZ PC Screen no.
n+1
n+2
n+3
Tag bit field * Note 1
(Used to turn tag display on/off, display status screen segments, and display settings)
•
(Used to turn tag display on/off, display status screen segments, and display settings)
•
•
Tag field * Note 1
(Used to switch tags, specify movements, and reference and set data)
•
(Used to switch tags, specify movements, and reference and set data)
Output destination relay
Bit configuration
Address
F E D C B A 9 8 7 6 5 4 3 2 1 0
System switch out-
put destination Function switch out-
put destination
Displayed screen data (no. of screen
n
Not supported
* Note 2 Not supported
* Note 2
Displayed screen data (no. of screen
currently displayed)
n+1 BAT SET
n+2
n+3
Output destination relay * Note 1
•
Output destination relay * Note 1
(Used for switch output destinations of tags, segments, and manual switches)
•
NOTES
1) The tag bit field and tag field under “Reference data area”, and the
output destination relay field under “Output relay” can be switched
just as they are, as device setting destinations for GT10 parts
functions.
2) System switch output destinations and function switch output
destinations provided in conventional models as the initial
addresses under “Output relay” are not supported with the GT10.
System field
(fixed at 2
words)
Field for
user use
(fixed at
126 words
maximum)
System field
(fixed at 2
words)
Field for
user use
(fixed at 30
words max-
imum)