Motorola GT10 - Manual (Page 135)

GT10/GT30 6.3 Entering Configuration Settings from the GT30
112
Format: Transmission format
This sets the communication parameters (data length, stop bits, parity) for the external
device (PLC) connected to the GT30.
The items displayed are: Data length / Stop bit / Parity, and each time the [Function] key
is pressed, the display switches in the sequence of: [7/1/None], [7/1/Odd], [7/1/Even]
[8/1/None], [8/1/Odd], [8/1/Even].
Set the parameter to match those of the PLC connected to the GT30.
SHORTCUTS
[RETURN]To complete the settings and return to the previous screen,
touch the [ESC] key.
EXPLANATION
TOOL Port communication parameter settings
The default (initial) values for the TOOL Port communication
parameter settings are: 19200 bits/s, 8/1/Odd.
COM. port communication parameter settings
The default (initial) values for the COM. port communication
parameter settings are: 19200 bits/s, 8/1/Odd.
6.3.6 Setting Mode: “Memory Initialization” (Clear Memory)
Touching [Setting] on the initial screen of the system menu and then the [Memory] key
of the setting mode menu displays the memory initialization screen. The internal user
memory of the GT30 is initialized here.
Memory initialization screen
Procedure for bringing up the screen
[Initial screen]
↓
[Memory]
Touching the [SRAM] key deletes clock data and Hold PLC Device data held in the
SRAM.
Touching the [FROM] key deletes screen data and main unit configuration settings
saved to the main unit user memory (F–ROM).