Multi-Tech Systems RF500S - Manual (Page 106)

106
Route Finder RF500S User Guide
Make Your New Connection (Unix Server Connection):
Windows 95/98:
1. Double-click My Computer.
2. Double-click the Dial-Up Networking folder.
3. Double-click Make New Connection (or Add New Connection, Win98).
4. Follow the onscreen instructions to configure your connection.
Windows NT:
1.
Double-click My Computer.
2. Double-click Dial-Up Networking.
3. When the Dial-Up Networking dialog box opens, click Install.
4. Follow the onscreen instructions to configure your connection.
Set Dial-up type (Unix Server Connection):
Windows 95/98:
1.
Right-click the newly created connection icon, then click Properties; the My Connection dialog
box opens.
2. On the General tab, click Server Type; the Server Types dialog box opens. Select PPP: Windows
95, Windows NT 3.5, Internet.
3. Click (to check or enable) only the following items: Log on to network, Enable software
compression, and TCP/IP. [Note: do not disturb any other items that are already checked.]
Dial in to your network (Unix Server Connection):
Windows 95/98:
1.
You are ready to dial in to your network.
2. Double-click the new connection icon; the Connect To dialog box opens.
3. Enter the user name (if necessary) and password configured for you on the RF500S.
Note: If your particular situation permits, click (to check) Save password.
4. Click Connect.
5. After connecting to the RF500S, you can access the same services and resources as if you were
connected to the network locally.