Routefinder manager – Multi-Tech Systems RF500S User Manual
Page 39
39
Chapter 5 - RouteFinder Manager
RouteFinder Manager
RouteFinder manager is the main program used to configure all the settings of your RF500S.
1.
To run RouteFinder Manager, click on the RouteFinder Manager icon on your desktop, or click
Start | Programs | RouteFinder Manager | RouteFinder Manager.
2.
The Manager dialog box displays.
3.
The RF500S automatically searches your network for devices available for configuration and
displays them in the Available Devices list box.
Note: Before using any of the Manager options, you must select the device you are attempting to
configure from the Available Devices list. If you need to update the list, click Refresh Device
List. You must exit RouteFinder Manager before using the device.
After you have selected a device from the
Available Devices list, the Status field provides
information about the name, IP address, MAC address and Firmware version of your RouteFinder.
The buttons in the left column of the screen offer the ability to change the device’s name and
password, save and load settings, upgrade the firmware or run general diagnostics on the device.
The buttons in the right column provide access to advanced configuration options for General
Settings, Port Settings, LAN DHCP Server Options, Router Settings and Filter Settings.
Additional information about all of these options is included in this chapter.
Note: If the IP address of the device you are attempting to configure is not within the same
subnet, the “Please Set the Device IP” dialog box displays, requesting you to input an IP
address in the same subnet.
Should an error message appear, refer to the Troubleshooting chapter of this User Guide.