Muratec F-300 - Manual (Page 55)

3-3 A
UTODIALLER
& D
IALLING OPTIONS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
A
UT
ODIALLER
& D
IALLING
OPTIONS
Special dialing characters
Your machine allows you to enter special dialing characters when registering the autodi-
aler. The chart below briefly describes each of these characters. It also tells you how to
store those characters in your autodialer.
Character Description Keystroke
/P
Each pause lasts two seconds.
If you must wait for another dial tone or signal at
any point in the dialing sequence, enter a pause.
(You can change the pause length. See page 10-6.)
Press [Advanced Functions]
repeatedly until “Pause /Dial
Opt.” appears, then press
[Enter].
– or –
Press once the soft key that
“Pause /Dial Opt.” is assigned
to.
– Makes long numbers easier to be read.
Press [Advanced Functions]
repeatedly until “Pause /Dial
Opt.” appears, then press
[Enter]. Repeat this proce-
dure until the “–” character
appears on the LCD.
– or –
Press the “Pause /Dial Opt.”
soft key twice.
/T
Switches from pulse-dialing to tone-dialing.
No need to use this character when using a tone
line.
Press [Advanced Functions]
repeatedly until “Pause /Dial
Opt.” appears, then press
[Enter]. Repeat this proce-
dure until the “/T” character
appears on the LCD.
– or –
Press the “Pause /Dial Opt.”
soft key until a “/T” appears.
/N
Enters a “Dial prefix code” to access the alternative
telephone network.
“/N” must be entered before the first of number.
Press [Advanced Functions]
repeatedly until “Dial Prefix
(/N)” appears and press
[Enter]. Repeat this proce-
dure until the “/N” character
appears on the LCD.
– or –
Press the “Pause /Dial Opt.”
soft key until “/N” appears.
NOTE: For details on how to assign “Pause /Dial Opt.” to a soft key, see page 8-2.
“Pause/Dial Opt.” is defaulted to a soft key in F-300.