Muratec F-300 - Manual (Page 62)

3-10 A
UTODIALLER
& D
IALLING OPTIONS
Erasing a call group
1
Press [Menu], [1], [3], [2], then [Enter].
2
Press [ ] or [ ] to select the call group you want to erase.
You can also select the call group by directly entering the two-digit identifier code
(01-32).
3
Press [Enter] twice.
If you want to exit without erasing, press [Cancel].
4
To erase another call group, repeat the procedure from step 2.
Otherwise, press [Reset] to exit and return to the standby mode.
How to dial using a call group
Press this key twice.
Enter group number. Press Start. MFX-1330 control panel
To perform call group fax dialing
1
Switch to the Fax mode by pressing [COPY

FAX

SCAN].
2
Place the document on the ADF or the document glass.
3
When you use the document glass, select the document size by pressing [Doc. Size].
4
Adjust the document resolution and contrast.
5
Press [Speed Dial /Group] twice.
Enter Group No.
G_
6
Use the numeric keys to enter the two-digit call group number.
7
Press [Start].
NOTE: The document glass is available only for the MFX-1330.