Muratec F-300 - Manual (Page 68)

4-4 S
ENDING FAXES
Sending a fax
Memory transmission
Sending a fax using the ADF
1
Switch to the Fax mode by pressing [COPY

FAX

SCAN].
Fax Ready
Nov 27 2004 2:15pm
2
Place your document on the ADF. (See page 2-11 for details.)
3
Adjust the scanning resolution and contrast.(See page 4-2.)
4
Dial the fax number.
• Use the numeric keys to dial the number.
–or–
• Press a one-touch key. (See page 3-6.)
–or–
• Press [Speed Dial /Group] and the three-digit code. (See page 3-8.)
–or–
• Use call group dialing. (See page 3-10.)
–or–
• Use the phone directory dialing. (See page 3-11.)
5
Press [Start]. (If you pressed a one-touch key, no need to press [Start].)
By pressing [Start], you have given your machine a command.
This command number appears on the first line of the LCD for a few seconds. You will
need to know this command number if youwant to cancel the transmission or print a
stored document (See “ Reviewing or canceling commands ” on page 4-8).
== Command:01 ==
6
At the end of the operation, your machine beeps and displays:
** Complete **
Whenever you transmit a document, what actually appears on the top line of the LCD depends
on the information stored in the remote fax machine. The line may even be blank.
NOTE: If you want to cancel a transmission during document scanning, press [Stop].
If you want to cancel a transmission that is in progress, use the Review Commands
feature.
See “Reviewing or canceling commands” on page 4-8.
NOTE: If the call fails, see “Redialing” on page 4-7.