Muratec F-300 - Manual (Page 59)

3-7 A
UTODIALLER
& D
IALLING OPTIONS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
A
UT
ODIALLER
& D
IALLING
OPTIONS
Speed-dial numbers
Adding or editing a speed-dial number
Your machine can store up to 160 speed-dial numbers, each designated by a three-digit
identifier codes (001 through 160.)
1
Press [Menu], [1], [2], [1], then [Enter]. The empty speed-dial number will be shown.
Enter Speed Dial No.
001:No Number Stored
2
Press [ ] or [ ] to select a speed-dial number.
You can also select a speed-dial number by directly entering that three-digit identifier
code (001-160).
3
Press [Enter].
001:Fax Number
_
4
Use the numeric keys to enter the number as if performing a manual dial. The num-
ber can hold up to 40 characters:
To change the number, press [ ] or [ ] to move the cursor and press [Cancel] to
erase the number. Then enter the correct number.
5
Press [Enter].
001:Name ;Upper
_
6
Use the numeric keys to enter the speed dial name.
The name can hold up to 24 characters.
(Regarding how to enter characters, see “Entering character,” on page 2-2.)
To change the name, press [ ] or [ ] to move the cursor and press [Cancel] to erase
the name. Then enter the name correctly.
7
Press [Enter] to save the setting.
The next empty speed-dial number will be shown.
8
To enter another speed-dial number, repeat this procedure from step 2.
To exit the operation and return to the standby mode, press [Reset].
NOTE: To print a list of speed-dial numbers, press [Menu], [5], [1], [0], [8], then [Enter].
Erasing a speed-dial number
1
Press [Menu], [1], [2], [2], then [Enter].
2
Press [ ] or [ ] to select the speed-dial number.
You can also select the speed-dial number by directly entering that three-digit identi-
fier code.
3
Press [Enter] twice.
If you want to exit without erasing, press [Cancel].
4
To erase another speed-dial number, repeat this procedure from step 2.
Otherwise, press [Reset] to return to the standby mode.