Inter-Tel CS-5400 - Manual (Page 140)

System Features
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Page 122 Endpoint Feature Codes
Do-Not-Disturb
Do-Not-Disturb Cancel
Do-Not-Disturb On/Off 370
371
372 The Do-Not-Disturb feature code halts all
intercom calls, transferred calls, and pages to
the endpoint. The Cancel code returns the
endpoint to normal operation. The on/off code
can be used to turn Do-Not-Disturb on or off.
(Inter-Tel endpoints use the DND button.)
Do-Not-Disturb Override 373 (Not used on single line endpoints) If enabled
in the database, allows the endpoint user to
break through another endpoint’s Do-Not-Dis-
turb mode when placing an intercom call
Enhanced Speakerphone Enable 310 (Digital endpoints only) When entered at a
digital phone, this feature code enables the
enhanced speakerphone as described in “Dis-
play and Nondisplay Digital Phones’’ on
page 102 . Digital endpoints can also use the
Special button + Speaker buttons.
Feature Key Default 395 (Not used on single line endpoints) endpoints
have user-programmable feature buttons that
can be set to enter feature codes. This code
returns the user-programmable buttons to the
database default values.
Group Listen 312 (Not used on single line endpoints) Allows a
user to transmit a conversation over the end-
point speaker while in handset or headset
mode
Handsfree On/Off 319 (Not used on single line endpoints) Disables/
enables the endpoint’s handsfree intercom
answering. Incoming intercom calls ring as pri-
vate calls if handsfree answering is disabled.
Headset Enable
Headset Disable
Headset On/Off 315
316
317 (Not used on single line endpoints) The
enable code signals the system that a headset
has been connected to the endpoint. The dis-
able code returns the endpoint to normal oper-
ation. The on/off feature code can be used to
toggle the feature on or off.
Hold – Individual 336 Places a call on hold so that it can be picked
up directly at that endpoint or through a
reverse transfer from any other endpoint.
(Inter-Tel endpoints use the HOLD button.)
Hold – System 335 Places an outside call on system hold. It can
be picked up directly at any endpoint that has
an individual trunk button and has allowed-
answer and/or outgoing access for that trunk,
or by the endpoint that placed it on hold. (If
used on conference or intercom calls, the sys-
tem places the call on individual hold.)
Hunt Group Remove
Hunt Group Replace
Hunt Group Remove/Replace 322
323
324 Removes the endpoint from its assigned hunt
group(s) or places it in again. Does not affect
non-hunt group calls. The remove/replace fea-
ture code can be used to toggle the feature.
Table 19. Endpoint Feature Code Definitions(Continued)
FEATURE NAME CODE DEFINITION