Inter-Tel CS-5400 - Manual (Page 49)

Administrator Procedures
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Endpoint Database Programming Flowchart
Page 31
Figure 1. Endpoint Database Programming Flowchart
Enter Program Database
feature code 9932
Press 1 or ENDPOINT
menu button
ENTER DATABASE OPTION
ENTER ENDPOINT EXTENSION
Enter desired endpoint extension number, then #
ENTER ENDPOINT OPTION
Press 2 or ENDPOINT INFO
menu button
ENDPOINT INFO OPTION
Press 3 or TOLL RESTRICTION
menu button
TOLL RESTRICTION OPTION
Press 1 or ENDPOINT FLAGS
menu button
Select flag to program
Press 1 or
ATTENDANT
menu button
Press 2 or
USERNAME
menu button
Enter
new
username extension
Enter
Attendant’s
Press 1 or
ON menu button
to enable
Press 2 or
OFF menu button
to disable
Press 1 or COS
DAY menu button
for day mode
Press 2 or COS
NIGHT menu button
for night mode
SET DAY/NIGHT COS XX
If necessary, select COS number
Press 1 or
ON menu button
to enable COS
If desired, select another COS number
to program by scrolling
Press 2 or
OFF menu button
to disable COS
to program by scrolling
YOUR INPUT
ENDPOINT DISPLAYS
AT ANY LEVEL:
Press * or the Speaker button to cancel any un-
saved changes and back up to exit program-
ming.
Press # or ACCEPT to save changes and back
up one display level.
INFORMATION IN THIS CHART IS SHOWN
AS FOLLOWS: