Inter-Tel CS-5400 User Manual
Page 57
Administrator Procedures
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Trunk Programming
Page 39
Trunk groups:
•
Day/Night Answer Access: You can program separate lists for phones with allowed-
answer access in day and night modes.
•
Day/Night Ring-In: You can program separate lists of endpoints with ring-in for day
and night modes.
•
Change Toll Restrictions: You can program toll restriction classes of service for the
trunk groups. Classes of service are described in detail on
.
•
Trunk List: Each trunk group has a programmed list of individual trunks.
The Trunk Database Programming process is summarized in the flowchart shown on
See
for a Program Planning Sheet.
Entering extension numbers:
When the procedure asks you to enter an endpoint, trunk, or trunk group extension number,
you can use any of the following methods. (If you enter an invalid extension number, you hear
reorder tones and must try again.)
•
Enter a complete number: Enter the extension number using your dialpad. When the
circuit information is displayed, press
again to continue.
•
Enter a partial number: Enter a partial extension number then press
, the high end
of the Volume button, or the
menu button. The display shows the extension number,
username and circuit number of the endpoint, trunk, or trunk group that most closely
matches the partial extension number. Press
or
ACCEPT
to accept the displayed
extension, or scroll to another endpoint as described below.
•
Scroll through the numbers: To scroll through the extension number list, press the
high end of the Volume button or the
NEXT
menu button to scroll forward, or press the
low end of the Volume button or the
PREVIOUS
menu button to scroll backward. When
the desired extension number is displayed, press
or
ACCEPT
to continue.
To program trunk information:
1.
While on-hook, enter the Program Database feature code (9932).
2.
If a password is required, the display shows ENTER PASSWORD. Use the dialpad to
enter your 1–8 digit password and press
. (If you enter an incorrect password, the
display shows INVALID PASSWORD.)
If a password is not required, skip this step.
3.
The display shows ENTER DATABASE OPTION. Six-line display phones also show
the following options: ENDPOINT, SYSTEM, and TRUNK. Press
or the
TRUNK
menu button. The display shows ENTER TRUNK OPTION.
4.
To Program an Individual Trunk: Press
or the
INDIVIDUAL TRUNK
menu button.
Then program trunk options as follows:
a.
The display shows ENTER TRUNK EXTENSION. Enter the extension number of
the trunk to be programmed using one of the methods described on
b.
The display shows INDIVIDUAL TRUNK OPTION. Enter one of the following
options. To view the last two options on a display phone, press the arrow (<< or
>>) menu button at the bottom of the display.
Answer Supervision: To program the answer supervision for the trunk, press
or
the
ANS SUPERVISION
menu button. When the display shows ANS SUPERVI-
NOTE
If necessary, at any time during the following procedure you can press the aster-
isk (
) or Speaker button to cancel programming and discard any unsaved
changes.
#
#
#
#
#
#
3
1
1