Inter-Tel CS-5400 - Manual (Page 15)

FCC Regulations
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Page xi
This equipment generates and uses radio frequency (RF) energy and if not installed and used
properly, that is, in strict accordance with the manufacturer’s instructions, may cause interfer-
ence to radio and television reception. It has been type tested and found to comply with the
limits for a Class A computing device in accordance with the specifications in Subpart J of Part
15 of FCC Rules. Operation of this equipment in a residential area may cause unacceptable
interference to radio and TV reception requiring the operator to take whatever steps are neces-
sary to correct the interference. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following measures:
•
Reorient the receiving antenna.
•
Relocate the equipment chassis with respect to the receiver.
•
Check that the equipment chassis and receiver are not on the same circuit; the equip-
ment must be powered from an isolated, dedicated AC outlet.
•
If necessary, the user should consult the dealer or an experienced radio/television tech-
nician for additional suggestions. The user may find the following booklet prepared by
the FCC helpful: “How to Identify and Resolve Radio-TV Interference Problems.”
This booklet is available from the U.S. Government Printing Office, Washington, D.C.
20402, Stock No. 004-000-00398-5.
If radio frequency interference (RFI) problems persist, contact Inter-Tel Customer Sup-
port.
The is now product safety certified by Canadian Standards Association (CSA) for use in
both the United States and Canada.
NOTICE
The telephone instruments specifically designed for this system have hearing aid-compatible
handsets that are in compliance with section 68.316 of the FCC Rules.
The IP SLA complies with UL60950/CSA60950 and EN 60950 standards and complies with
EN 55022 and CFR 47 part 15 of the FCC Rules.