Inter-Tel CS-5400 - Manual (Page 142)

System Features
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Page 124 Endpoint Feature Codes
Record-A-Call 385 If the system is programmed with a Record-A-
Call application, the endpoints can be pro-
grammed to use the Record-A-Call feature. It
allows users to enter a feature code whenever
they want to record an ongoing call in their
designated Record-A-Call mailbox. Users can
retrieve the recorded messages later, just as
they would any other mailbox messages.
Redial 380 Redials the last outside phone number dialed
or saved at the endpoint (up to 48 digits). Also
used to save numbers at endpoints pro-
grammed for last number saved. (Inter-Tel
endpoints use the REDIAL button.)
Redirect Call 331 This feature allows the endpoint user to route
ringing outside, intercom, and camped on
calls to another endpoint, hunt group, or out-
side number. Routing of the redirected call is
still subject to trunk and toll restrictions. This
feature provides these options in addition to
the currently available options which allow the
endpoint user to redirect calls to Voice Mail or
Do-Not-Disturb. The Redirect Ringing Call fea-
ture does not require any premium features.
Reminder Message
Reminder Message Cancel 305
306 (Not used on single line endpoints) The end-
point user can set reminder messages that
signal the endpoint at specific times. Or, the
user can cancel all reminder messages for the
endpoint.
Remote Programming 359 Allows a user to place an endpoint in DND
mode, forward the endpoint’s calls, or change
the password; either from another endpoint or
through DISA.
Reverse Transfer (Call Pick-Up) 4 Picks up a call ringing or holding at an end-
point or hunt group
Review Keys 396 (Not used on single line endpoints) User-pro-
grammable feature buttons and Station Speed
Dial buttons can be viewed using this feature
code.
Ring Intercom Always On/Off 377 Enables/disables the feature that allows the
endpoint to always place private (non-hands-
free) intercom calls.
Ring Tone Selection 398 (Not used on single line endpoints) Selects
the type of ringing alert tone that will be heard
from the endpoint.
Routing Off 304 Disables System OAI Offering Control for
third-party applications. This feature requires
you to enter a password. Once you disable
routing, you cannot enable it again (i.e., only
the third-party application can enable routing).
Table 19. Endpoint Feature Code Definitions(Continued)
FEATURE NAME CODE DEFINITION