SATO MB200/201i - Manual (Page 19)

Setup
2-5
Charging the battery pack with a charger
If your printer comes with the optional battery
charger, you can use it to charge the supplied battery
pack. Follow the steps below:
1. Connect the charger to the
wall outlet and turn on the
power. The POWER lamp
lights red.
2. Align the battery pack with its
metal contacts facing front,
and slide it forward into the
charger.
The CHARGE lamp lights red
when charging starts. It
turns off when the battery
pack is fully charged. In the
case of a five-battery
charger, when charging
starts, the CHARGE lamp
glows red. It then glows
green when the battery
packs are fully charged.
3. After charging, remove the
battery pack from the
charger by sliding it out.
metal contacts
MB20xi A6.book Page 5 Friday, May 27, 2005 5:12 PM