Operation and configuration, Printer modes (cont’d), Setting head check area (cover must be left open) – SATO MB200/201i User Manual
Page 45
Operation and Configuration
3-15
Printer modes (cont’d)
Head Check Setting Mode
Head checking can be applied to one of two areas:
the normal print area and the barcode print area.
To specify the area subjected to a head check, follow
the settings in the table below:
You can check the current setting with a test printout
as described in “Performing a Test Print” on page 2.
When setting the Head Check options, the STATUS
LED blinks green, and turns into a steady green
signal upon completion of setting. Turn off the printer
ONLY when the STATUS LED is a steady green light.
Setting Head Check Area
(cover must be left open)
H.Check setting
DSW-1
DSW-2
DSW-3
DSW-4
Other keys
Normal Print Area
OFF
ON
OFF
ON
hold down PRINT
button
Disable H. Check
OFF
ON
OFF
ON
hold down FEED
button
Barcode Print Area
ON
OFF
OFF
ON
hold down PRINT
button
Disable H. Check
ON
OFF
OFF
ON
hold down FEED
button
MB20xi A6.book Page 15 Friday, May 27, 2005 5:12 PM