SATO MB200/201i - Manual (Page 39)

Operation and Configuration
3-9
Printing Procedure
After the proper setup and basic configuration
procedures, you are ready to print to the
MB200/201i.
1. Make sure the host
computer is ready to
transmit data, and ensure
that the STATUS LED is lit.
(Press the PRINT button to
take the printer ONLINE).
2. Start the print job from the
computer. When printing is
finished, pinch either the left
or right corner of the printed
roll of label(s) and tear it off
in the direction of the arrow
in the diagram.
Notes
• The number of sheets you can print is determined
by the printer’s mode (continuous or peel mode).
• When printing non-separate labels and you have
torn the labels at a wrong place, stop the printing
and follow the instructions on the next page to
correct the print job.
MB20xi A6.book Page 9 Friday, May 27, 2005 5:12 PM