SATO MB200/201i - Manual (Page 47)

Operation and Configuration
3-17
Offset Configuration via Programming
The following offset adjustments for the MB200/201i
printer are usually unnecessary. Almost all
adjustments are electrical in nature due to the
printer’s advanced self aligning and balancing design
features. However, if you need to perform the
adjustments, they can be sent as commands to the
printer. Consult your SATO representative for
information on programming the MB200/201i printer,
or refer to the Programming Reference guide found
on the CD-ROM.
POSITION ADJUSTMENTS
Adjustment Method Description
Printer Setting
Commands Use the <PG>
programming
command. Saves the values
to the Flash ROM.
Base Point Offset
Pitch Offset
Dispense Offset
Tear-Off Offset
Base Point Offset Use the <A3>
programming
command.
Takes effect
instantly; the
value is cleared
once the power is
turned off.
MB20xi A6.book Page 17 Friday, May 27, 2005 5:12 PM