SATO MB200/201i - Manual (Page 35)

Operation and Configuration
3-5
Printing via the Wireless LAN Interface
To print using the Wireless LAN MB200/201i, you
need to have a properly configured wireless LAN set
up. The next step is to configure the MB200/201i to
share the same network settings in order to establish
communication.
1) Check the DIP Switches:
The printer’s DIP switches are factory set for WLAN
operation. Check that Dip switch 1 is OFF and Dip switch 2 is
ON. In case you need to reset other switches, refer to the full
DIP-Switch table in the next chapter, Interface Specifications.
2) Setup a connection to the Wireless Network
The next step is to ensure that your printer is
configured with the proper IP address, subnet mask,
gateway, SSID, Channel, WLAN mode and
security settings. Refer to your MIS personnel for
details of your existing wireless network settings.
Your SATO-certified System Integrator/dealer can
help to set up the connection to your corporate
wireless network. To configure the printer yourself,
consult them for the necessary software tools.
Note
When printing with the WLAN interface, the usable
range between the printer and the host may vary
depending on the usage environment and the
capabilities of the connected devices.
MB20xi A6.book Page 5 Friday, May 27, 2005 5:12 PM